This post could easily be a sidebar to two previous posts. It describes a variation on a button doubling, in this case including an ebony crown and a tricky bit of edge replacement. More importantly, in my mind, as another example of a Disappearing Act, it expresses again the “Restorer’s Mind”.
This fiddle came into my shop after a memorable night of live bluegrass, performed on the stage that apparently ate that little piece of maple, which, in its absence, has inspired this post. “Is it possible that it’s in the case?” I asked my client. Sometimes I get lucky, but not this time. Maybe it was inadvertently kicked off the stage and since swept up by the janitor. Perhaps it landed in the dust accumulating in the open back of the bassist’s amp. Maybe it secreted itself in the upturned cuff of the bassist’s jeans (always blame the bassist if you can, if there is no horn section). In the slim chance that there is a baritone sax around, the likelihood is that the missing piece will end up in the bell. Not likely in a bluegrass set. In any case our little bit was gone, gone, gone.
Being a restorer, I am always thinking about what I might otherwise be throwing away, and if there is any chance it might be useful. Rather than searching through my stores of repair wood, I found the perfect match right under my nose. There is a certain amount of wood that has to be taken away in the course of repairing the back button. With some careful planning and a fine toothed saw, I was able to “harvest” a chip that could be reoriented and fit to fill the gap left by the wayward chip now seeking its fortune in Nashville. Here is a series of thumbnails, any of which can be enlarged. Hopefully, you will get the sense of the procedure.
In my shop, this is a typical approach to assuring a match when some bit of original material is missing. The first thing I think about is what is about to land on the floor. There’s likely to be some good stuff there.
restorersmind 